Benderlink for Pines

From ATTWiki
Revision as of 01:09, 1 May 2008 by Mcone (Talk | contribs)

Jump to: navigation, search
Light arrows.jpg

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers. Blinkpines v2 mainscreen.jpg

TS-2000 Control to Vector 1 Laservision

Ts-2000.jpg The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box.

EL Laservision Tube Data Center.jpg

Versions

Version 1.0 - ATT Protocol (Competitive Bender Interface)

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges.


This CBI kit was costly and time-consuming for the customer. Version 2 of our software addressed this issue.

Blinkpines v1 mainscreen.jpg

Version 2.0 - Legacy Protocols

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No measuring center upgrade is necessary.


This version makes any PINES bender answer as a Velog, EL-2000, or Premier control.

Both STANDARD and EXTENDED protocols are handled. The Extended protocol is intended for multiple radius benders.

Blinkpines v2 mainscreen.jpg


LASERVISION.jpg
PINES bender.jpg

Other Pages

Back to the Benderlink Page