Difference between revisions of "CNC Bender v14.7"
From ATTWiki
(→25px NEW: "Custom ALL DIES Open" Option) |
(→25px NEW: "Custom ALL DIES Open" Option) |
||
| Line 40: | Line 40: | ||
<td width=500> | <td width=500> | ||
[[image:cncbender_v14.7_customalldiesopenoption.png|500px]] | [[image:cncbender_v14.7_customalldiesopenoption.png|500px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | |||
| + | ==[[image:Check.jpg|25px]] NEW: "Custom ALL DIES Open" Check and Warning Messages== | ||
| + | |||
| + | <table> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | A Prebend warning will display when the new Custom ALL DIES Open option is enabled.<br><br> | ||
| + | <td width=500> | ||
| + | [[image:cncbender_v14.7_custom_all_dies_open_option_messages.png|500px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 22:46, 24 July 2015
v14.7 - July 11, 2014
|
|
ENHANCED: Version 14 Is Now Compatible with Legacy I2T Servo Modules
|
Version 14 introduced compatibility with the new Galil module. This revision allows version 14 to communicate with legacy I2T modules also. |
|
NEW: "Custom ALL DIES Open" Option
|
This new option, when enabled, allows the operator to take over the control of how ALL dies open after each bend using CUSTOM COMMANDS. |
|
NEW: "Custom ALL DIES Open" Check and Warning Messages
|
A Prebend warning will display when the new Custom ALL DIES Open option is enabled. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
