Difference between revisions of "CNC Bender v14.7"
From ATTWiki
(→25px ENHANCED: Version 14 Is Now Compatible with I2T or Galil Modules) |
(→25px NEW: "Custom ALL DIES Open" Option) |
||
| Line 37: | Line 37: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | This new option, when enabled, allows the operator to take over the control of | + | This new option, when enabled, allows the operator to take over the control of how ALL dies open after each bend using CUSTOM COMMANDS.<br><br> |
<td width=500> | <td width=500> | ||
[[image:cncbender_v14.7_customalldiesopenoption.png|500px]] | [[image:cncbender_v14.7_customalldiesopenoption.png|500px]] | ||
Revision as of 22:34, 24 July 2015
v14.7 - July 11, 2014
|
|
ENHANCED: Version 14 Is Now Compatible with Legacy I2T Servo Modules
|
Version 14 introduced compatibility with the new Galil module. This revision allows version 14 to communicate with legacy I2T modules also. |
|
NEW: "Custom ALL DIES Open" Option
|
This new option, when enabled, allows the operator to take over the control of how ALL dies open after each bend using CUSTOM COMMANDS. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
