Difference between revisions of "CNC Bender v12-20100903"
Line 169: | Line 169: | ||
* Feed Position for Output Down | * Feed Position for Output Down | ||
* CIO Name of Tube Support Output Down | * CIO Name of Tube Support Output Down | ||
− | '' | + | * ''CIO Name of Tube Support Output Up'' |
* Feed Position for check Input Down | * Feed Position for check Input Down | ||
* CIO Name of Tube Support Input Down | * CIO Name of Tube Support Input Down |
Revision as of 00:17, 1 September 2010
NEW - CYCLE HOLD in Custom Commands and in TEACH Mode
Now CYCLE HOLD anywhere inside a CUSTOM COMMAND either manually entered or taught during TEACH MODE. |
|
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
ENHANCED - Added CNC Processor Automatic High Pressure Handling
CNC Processor now uses the CIO Name Cross Reference in the Low Level menu to automatically set the high pressure under these two special circumstances:
|
|
ENHANCED - CNC Processor Soft EOT with New Ramp-Down for JOG Speeds
ENHANCED - EMBEDDED TUBE SUPPORT in CNC PROCESSOR
This feature allows CNC Bender's PROCESSOR to control when the tube support is lifted or dropped - and if the drop should be confirmed with an input. This revision adds the CIO Name of Tube Support Output UP in addition to the Down CIO name.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands