Difference between revisions of "Benderlink Module - Chiyoda/KEINS"

Latest revision as of 18:20, 10 October 2008

This version of the Benderlink Module connects Chiyoda and KEINS benders.

Each module assigns a TCP/IP address to the bender for communications at any distance over Ethernet.

This is an image of the same box installed on a Chiyoda bender.

@@ Line 1: / Line 1: @@
 [[image:Blink_chiyoda_ethernet_module.jpg|400px]]
-This version of the Benderlink Module connects Eaton Leonard Laservision legacy electronics (commonly called "current loop") to a Crown Unlimited bender.
+This version of the Benderlink Module connects [[Chiyoda]] and [[KEINS]] benders.
+===Ethernet - IP Address Assignment to Chiyoda===
+Each module assigns a TCP/IP address to the bender for communications at any distance over Ethernet.
+[[image:Blink_chiyoda_ethernet_module_ports.jpg|400px]]
-This model was designed to connect two Laservision measuring centers to one Crown bender.   The two Amphenol circular ports use the Eaton Leonard communications cable standard.  The ports are switched using an industrial AB switch embedded into the Benderlink module.
+===Installation on the Bender===
+This is an image of the same box installed on a [[Chiyoda]] bender.<br>
-===CB-EL1 Electronics Board===
+[[image:Blink_chiyoda_ethernet_module_installed.jpg|400px]]
-[[image:cb-el1_render1.jpg|right|250px]]
-Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders.  See [[Communications Board for Eaton Leonard - CB-EL1]] for detailed information on our electronics.
-===Installation on Crown Bender===
-This is an image of the same box installed on a Crown bender control.
-[[image:Blinkmodule_crown.jpg|300px]]
-===See Also===
-This module works with [[Benderlink for Crown]] software.