Difference between revisions of "CNC Bender v11-20090126"
From ATTWiki
Line 26: | Line 26: | ||
<br> | <br> | ||
− | <table cellpadding=" | + | <table cellpadding="15"> |
− | <tr><td width= | + | <tr><td width=25></td> |
<td width=300 bgcolor="#f0f0f0"> | <td width=300 bgcolor="#f0f0f0"> | ||
<font size=5>[[image:Gear_warning.jpg]] <b>SAFETY NOTE</b><br><br></font> | <font size=5>[[image:Gear_warning.jpg]] <b>SAFETY NOTE</b><br><br></font> | ||
− | <font size=3>'''Do not''' set the HIGH value to any value above the recommend value from SMT - or the Feed Axis gear box or other parts of the carriage or carriage motion system | + | <font size=3>'''Do not''' set the HIGH value to any value above the recommend value from SMT - or the Feed Axis gear box or other parts of the carriage or carriage motion system could be damaged by high settings in the Bender Data page.<br><br> |
"25%" is typically the maximum recommend value for extended-run.<br><br> | "25%" is typically the maximum recommend value for extended-run.<br><br> | ||
Any higher value may damage the machine and possibly void the warranty. | Any higher value may damage the machine and possibly void the warranty. |
Revision as of 20:42, 26 January 2009
ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits
The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.
The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only. These values have no effect on the torque of the feed axis for any other type of feed motion.
These are the options before the change:
These are the options after the change:
Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables