Difference between revisions of "VTube-LASER v2.9.11"
(→25pxFIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT) |
(→25pxFIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT) |
||
Line 126: | Line 126: | ||
<td width=300> | <td width=300> | ||
− | The Bender Setup window could improperly attempt to display on a monitor that was available, but | + | The Bender Setup window could improperly attempt to display on a monitor that was available, but has become no longer available. This was a problem when opening a laptop monitor, then closing it while VTube-LASER was running.<br><br> |
+ | This has been resolved. | ||
Revision as of 03:04, 28 July 2018
Revision 2.9.11Release Date: July 27, 2018
|
NEW LASER SCAN LOGIC FOR RECTANGULAR AND SQUARE TUBES
IF YOU MEASURE SQUARE TUBES WITH THE LASER SCANNER, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. The rectangular and square LASER scanning logic is much improved compared to the previous version. |
FIX - RECTANGULAR PROBE COMPENSATION OFFSET DIRECTION LOGIC CORRECTED
IF YOU MEASURE SQUARE TUBES WITH A BALL PROBE, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. For TACTILE measuring, we discovered that the rectangular and square tube measurements might project the planes to the wrong side of the ball probe. This incorrect compensation would cause the centerline to shift by up to double the ball diameter. This has been fixed in this version. |
NEW - STAR TECHNOLOGY Bender Corrections Through a Network
We added the STAR EVO SVNet file correction support that allows VTube-LASER to correct STAR EVO benders through a network connection automatically.
Bender corrections only work through VTube-LASER. (Not VTube-STEP)
|
NEW - (NEW VALUE) MAXIMUM NUMBER OF POINTS ALLOWED IN END SCAN LASER STRIPE
This was added because the ROMER RS4 scanners give VTube-LASER too much data for end-stripes, thus slowing down the graphics engine and measuring process. |
FIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT
The Bender Setup window could improperly attempt to display on a monitor that was available, but has become no longer available. This was a problem when opening a laptop monitor, then closing it while VTube-LASER was running.
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature