Difference between revisions of "VTube-LASER v2.9.11"
(→25pxFIX - RECTANGULAR PROBE OFFSET DIRECTION LOGIC CORRECTED) |
(→25pxNEW - STAR TECNOLOGY Bender Corrections Through a Network (VTube-LASER Only)) |
||
Line 83: | Line 83: | ||
<br> | <br> | ||
− | See [[VTube STAR SVNet Bender | + | See [[VTube STAR SVNet Bender Communications]] |
</td> | </td> |
Revision as of 13:08, 23 July 2018
Revision 2.9.11Release Date: July 20, 2018
|
NEW LASER SCAN LOGIC FOR RECTANGULAR AND SQUARE TUBES
IF YOU MEASURE SQUARE TUBES WITH THE LASER SCANNER, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. The rectangular and square LASER scanning logic is much improved compared to the previous version. |
FIX - RECTANGULAR PROBE COMPENSATION FFSET DIRECTION LOGIC CORRECTED
IF YOU MEASURE SQUARE TUBES WITH A BALL PROBE, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. For TACTILE measuring, we discovered that the rectangular and square tube measurements might project the planes to the wrong side of the ball probe. This incorrect compensation would cause the centerline to shift by up to double the ball diameter. This has been fixed in this version. |
NEW - STAR TECNOLOGY Bender Corrections Through a Network (VTube-LASER Only)
NEW - (NEW VALUE) MAXIMUM NUMBER OF POINTS ALLOWED IN END SCAN LASER STRIPE
This was added because the ROMER RS4 scanners give VTube-LASER too much data for end-stripes, thus slowing down the graphics engine and measuring process. |
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature