Difference between revisions of "VTube-LASER v2.9.11"
(→25pxNEW LASER SCAN LOGIC FOR RECTANGULAR TUBES) |
(→25pxNEW - LASER SCAN FILTER SOUND) |
||
Line 45: | Line 45: | ||
<br><br> | <br><br> | ||
− | ==[[image:Check.jpg|25px]]NEW - | + | ==[[image:Check.jpg|25px]]NEW - RECTANGULAR PROBE OFFSET DIRECTION LOGIC CORRECTED== |
<table cellpadding=10 width=900> | <table cellpadding=10 width=900> | ||
Line 52: | Line 52: | ||
<td width=500> | <td width=500> | ||
− | + | <b>IF YOU MEASURE SQUARE TUBES WITH THE BALL PROBE, THEN THIS IS AN IMPORTANT UPDATE FOR YOU.</b><br><br> | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
+ | We discovered that the rectangular and square tube measurements might project the planes to the wrong side of the ball probe. This incorrect compensation would cause the centerline to shift by up to double the ball diameter.<br><br> | ||
+ | This has been fixed in this version. | ||
</td> | </td> | ||
<td> | <td> | ||
− | [[image: | + | [[image:vtl_2.9.11_correct_ball_compensation_for_planar.png|500px]]<br><br> |
− | + | ||
− | + | ||
− | + | ||
</td> | </td> | ||
Revision as of 20:16, 22 July 2018
Revision 2.9.11Release Date: July 20, 2018
|
NEW LASER SCAN LOGIC FOR RECTANGULAR AND SQUARE TUBES
The rectangular and square LASER scanning logic is much improved over the previous version. If you can square or rectangular tubes, then this version is especially important for you. |
NEW - RECTANGULAR PROBE OFFSET DIRECTION LOGIC CORRECTED
IF YOU MEASURE SQUARE TUBES WITH THE BALL PROBE, THEN THIS IS AN IMPORTANT UPDATE FOR YOU. We discovered that the rectangular and square tube measurements might project the planes to the wrong side of the ball probe. This incorrect compensation would cause the centerline to shift by up to double the ball diameter. This has been fixed in this version. |
NEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART
VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan.
We redesigned the scanning engine so it no longer requires this in-range scanning position. |
NEW - HERBER Bender Corrections Through a Network (VTube-LASER Only)
NEW - HERBER Bender Setup From Solid Model Through a Network (VTube-LASER or VTube-STEP)
NEW - VTUBE-LASER TUNED TO WORK WITH THE NEW FARO 6.1.2.7 USB DRIVER
FARO USB driver 6.1.2.7 is a rewrite of the USB driver. It has many improvements that are very much worthwhile - like the scanner calibration is much improved.
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature