Difference between revisions of "VTube-LASER v2.9.3"
(→25pxNEW - Guide Windows in Bender Setup) |
(→25pxNEW - NUMALLIANCE CORRECTIONS ADDED) |
||
Line 34: | Line 34: | ||
VTube-LASER now has an export option for NUMALLIANCE CSV files that is used to '''correct''' the NUMALLIANCE benders.<br><br> | VTube-LASER now has an export option for NUMALLIANCE CSV files that is used to '''correct''' the NUMALLIANCE benders.<br><br> | ||
Note: NUMALLIANCE benders only require the ''measured'' data for corrections.<br><br> | Note: NUMALLIANCE benders only require the ''measured'' data for corrections.<br><br> | ||
+ | Measure the tube in VTube-LASER, then send the MEASURED tube data to the bender control, and it will then perform the correction. | ||
</td> | </td> |
Revision as of 00:12, 19 January 2018
Revision 2.9.3Release Date: January 10, 2017
|
NEW - NUMALLIANCE CORRECTIONS ADDED
VTube-LASER now has an export option for NUMALLIANCE CSV files that is used to correct the NUMALLIANCE benders. |
NEW - REDESIGNED TUBE EXPORT MENU for QUICK EXPORT with NUMALLIANCE EXPORT ADDED
We redesigned the FILE menu for the MASTER, MEASURED, and MEASURED ALIGNED menus. Now it is referred to as EXPORT. |
NEW - Diameter Cut Plane - Maximum Cloud Radius ZERO Warning
VTube-LASER will take in only one point per laser stripe if the Maximum Cloud Radius value is accidentally zero to ZERO and the DCP is set to ACTIVE. |
NEW - DENGLER Bender Corrections Support ADDED
Dengler benders are known for bending long brake and fuel lines. |
NEW - Support for MicroScribe Arms from Revware
VTube-LASER now supports the MicroScribe arms using ball probes. |
NEW - GUIDE WINDOWS IN BENDER SETUP ADDED
We've put Guide Windows in the Bender Setup menu. They can stay open for as long you as you want - or close them anytime. They are less obtrusive than the dialogs that required the operator to press "OK" to continue. |
Other
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature