Difference between revisions of "VTube-LASER v2.9.2"
From ATTWiki
(→25pxFIXED and IMPROVED - Bend Profile) |
(→25pxFIXED and IMPROVED - Bend Profile) |
||
Line 43: | Line 43: | ||
− | ==[[image:Check.jpg|25px]]FIXED and IMPROVED - Bend Profile== | + | ==[[image:Check.jpg|25px]]FIXED and IMPROVED - Bend Profile Calculations== |
<table cellpadding=10 width=800> | <table cellpadding=10 width=800> |
Revision as of 21:55, 1 December 2017
Revision 2.9.2 Build 104Release Date: December 1, 2017
|
FIXED and IMPROVED - Split Bend - Finding Surface Edges
As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends. |
FIXED and IMPROVED - Bend Profile Calculations
The same issues that affected the Split Bend logic also affected the Bend Profile logic. |
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature