Difference between revisions of "CNC Bender v15.9.5"
(→25px NEW: Jog Motion "End Custom Commands") |
(→25px FIXED: Motion PDA Crash Protection in Manual Absolute) |
||
Line 43: | Line 43: | ||
<br><br> | <br><br> | ||
− | ==[[image:Check.jpg|25px]] FIXED: Motion PDA | + | ==[[image:Check.jpg|25px]] FIXED: Motion PDA Collision Protection in Manual Absolute== |
<table width=1000> | <table width=1000> | ||
<tr> | <tr> | ||
Line 56: | Line 56: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
− | |||
==[[image:Check.jpg|25px]] FIXED: Galil Communications Reset Issue== | ==[[image:Check.jpg|25px]] FIXED: Galil Communications Reset Issue== |
Revision as of 19:42, 16 September 2017
v15.9.5 - September 14, 2017
|
BIG CHANGE: CYCLE TIME REDUCTION for CUSTOM COMMAND USERS
"END CUSTOM COMMANDS" FEATURE
If you use CUSTOM COMMANDS in any of your bend programs in CNC Bender ProControl, then we strongly recommend that you upgrade to version 15.9.5 for this feature alone.The big change in this version is that CNC Bender allows the operator to skip unused CUSTOM COMMANDS in the process list. The end effective can be shaving several seconds off of cycle times for parts that use CUSTOM COMMANDS for avoidance moves during bending. |
FIXED: Window Border Feature
The Window border feature now correctly maximizes the CNC Bender window when the window border is toggled OFF. |
FIXED: Motion PDA Collision Protection in Manual Absolute
This change is for motion-controlled PDAs. |
FIXED: Galil Communications Reset Issue
CNC Bender can sometimes request a Galil motion controller communications reset on slower computers. |
FIXED: Call to Windows Onscreen Keyboard Working Again
CNC Bender could not load the Windows onscreen keyboard in Windows 7 and Windows 10 in 64 bit mode. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands