Difference between revisions of "VTube-LASER v2.8.1"
(→25px NEW: SECOND POINT OBJECT for END OFFSETS) |
(→25px NEW: SECOND POINT OBJECT for END OFFSETS) |
||
Line 35: | Line 35: | ||
In the image below, the top points show an extra -0.5 inch offset - in addition to the ball radius offset.<br><br> | In the image below, the top points show an extra -0.5 inch offset - in addition to the ball radius offset.<br><br> | ||
[[image:vtube-laser_v2.8.1_end_offset_model_illustration.png|300px]]<br><br> | [[image:vtube-laser_v2.8.1_end_offset_model_illustration.png|300px]]<br><br> | ||
− | When the two points are within 0.1 mm (0.0039 inches) of each other, then VTube only draws the final orange | + | When the two points are within 0.1 mm (0.0039 inches) of each other, then VTube only draws the final orange point. |
<td> | <td> | ||
</td> | </td> |
Revision as of 02:58, 7 May 2017
Revision 2.8.1Original Release Date: May 8, 2017
|
Contents |
BUILD 70 - May 6, 2017
NEW: SECOND POINT OBJECT for END OFFSETS
NEW: NOTIFICATION SWITCHING FROM LASER SCANNER TO BALL PROBE and BACK
As of this version if VTube-LASER toggles from LASER to ball probe or ball probe to LASER, it notifies you with a sound and a guide box message. |
NEW: SWITCH BETWEEN UNISCAN TO MULTISCAN IN THE SAME TUBE
As of this version if VTube-LASER allows you to toggle UNISCAN to MULTISCAN and back in the SAME tube. |
NEW: UNISCAN DCF (DUAL CYLINDER FIT) ADDED TO MULTISCAN
The DCF feature was only available in UNISCAN in the previous version. Now it is used in MULTISCAN too. |
Other Features and Fixes
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature