Difference between revisions of "VTube-LASER v2.8.1"
From ATTWiki
(→25px NEW: UNISCAN DCF (DUAL CYLINDER FIT) Feature) |
(→25px NEW: END OFFSET MODEL Feature) |
||
Line 31: | Line 31: | ||
<td width=300> | <td width=300> | ||
This adds a second model of the end point before it is offset.<br><br> | This adds a second model of the end point before it is offset.<br><br> | ||
− | This allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end. | + | This allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end.<br><br> |
+ | In the top image on the right, the yellow ball represents the middle of the ball probe. The orange ball is the projected end point based on the compensation toward the end. | ||
<td> | <td> | ||
</td> | </td> | ||
<td> | <td> | ||
[[image:vtube-laser_v2.8.1_end_offset_model.png|500px]]<br><br> | [[image:vtube-laser_v2.8.1_end_offset_model.png|500px]]<br><br> | ||
+ | [[image:ball probe orange tube.png|500px]] | ||
</tr> | </tr> | ||
</table> | </table> |
Revision as of 20:23, 6 May 2017
Revision 2.8.1Original Release Date: May 8, 2017
|
Contents |
BUILD 70 - May 6, 2017
NEW: END OFFSET MODEL Feature
This adds a second model of the end point before it is offset. |
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature