Difference between revisions of "VTube-LASER v2.8"
From ATTWiki
(→25px ENHANCED: Winton WMC Communications Improvement) |
(→NEW DIALOGS=) |
||
Line 77: | Line 77: | ||
The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process. | The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process. | ||
<br><br> | <br><br> | ||
− | ===NEW DIALOGS | + | ===NEW DIALOGS=== |
Steps 2 and 5 are new. They carefully explain what is happening during the correction process.<br><br> | Steps 2 and 5 are new. They carefully explain what is happening during the correction process.<br><br> | ||
Revision as of 01:12, 4 March 2017
Revision 2.8Release Date: Not Released
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
The Default Tolerance Ends value is in the Inspection Data menu.
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
BUILD 19 - February 22, 2017
ENHANCED: Winton WMC Communications Improvement
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature