Difference between revisions of "VTube-LASER v2.8"
From ATTWiki
(→25px ENHANCED: Winton WMC Communications Improvement) |
(→25px ENHANCED: Winton WMC Communications Improvement) |
||
Line 84: | Line 84: | ||
</td> | </td> | ||
<td> | <td> | ||
− | Immediately after the user presses the Auto Correction button, this dialog appears:<br> | + | Immediately after the user presses the Auto Correction button, this dialog appears (see step 2 below):<br><br> |
[[image:vtl_v2.8_winton_correction_existing_dialog.png|600px]]<br><br> | [[image:vtl_v2.8_winton_correction_existing_dialog.png|600px]]<br><br> | ||
− | Immediately after the user presses the Exit and Save setup data button (see step 4 below), this dialog appears:<br> | + | Immediately after the user presses the Exit and Save setup data button (see step 4 below), this dialog appears:<br><br> |
[[image:vtl_v2.8_winton_correction_overwrite_backup_dialog.png|600px]]<br><br> | [[image:vtl_v2.8_winton_correction_overwrite_backup_dialog.png|600px]]<br><br> | ||
Revision as of 01:08, 4 March 2017
Revision 2.8Release Date: Not Released
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
The Default Tolerance Ends value is in the Inspection Data menu.
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
BUILD 19 - February 22, 2017
ENHANCED: Winton WMC Communications Improvement
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature