Difference between revisions of "VTube-LASER v2.8"
From ATTWiki
(→BUILD 11 - February 15, 2017) |
(→25px ENHANCED: Winton WMC Communications) |
||
Line 70: | Line 70: | ||
=BUILD 19 - February 22, 2017= | =BUILD 19 - February 22, 2017= | ||
− | ==[[image:Check.jpg|25px]] ENHANCED: Winton WMC Communications== | + | ==[[image:Check.jpg|25px]] ENHANCED: Winton WMC Communications Improvement== |
<table cellpadding=10 width=900> | <table cellpadding=10 width=900> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
− | The | + | The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process. |
<br><br> | <br><br> | ||
− | + | Steps 2 and 5 are new. They carefully explain what is happening during the correction process.<br><br> | |
+ | Step 5 also explains that a BACKUP file is created during the process. This allows operators to always get back to the previous data if something goes wrong in the correction process. | ||
<br><br> | <br><br> | ||
<td> | <td> | ||
</td> | </td> | ||
<td> | <td> | ||
− | [[image: | + | [[image:vtl_v2.8_winton_correction_process.png|400px]]<br><br> |
+ | |||
</tr> | </tr> | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
− | |||
==[[image:Check.jpg|25px]] NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values== | ==[[image:Check.jpg|25px]] NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values== |
Revision as of 01:01, 4 March 2017
Revision 2.8Release Date: Not Released
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
The Default Tolerance Ends value is in the Inspection Data menu.
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
BUILD 19 - February 22, 2017
ENHANCED: Winton WMC Communications Improvement
The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process.
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature