Difference between revisions of "VTube-LASER v2.8"
From ATTWiki
(→Other Changes) |
(→25px NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values) |
||
Line 47: | Line 47: | ||
<td width=300> | <td width=300> | ||
Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation. | Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation. | ||
+ | <br><br> | ||
+ | The new commands are | ||
+ | |||
+ | * <code>array_dev_tmt_average</code><br> | ||
+ | * <code>array_dev_tmt_maximum</code> | ||
<br><br> | <br><br> | ||
See the example result in the report on the right.<br><br> | See the example result in the report on the right.<br><br> | ||
Line 54: | Line 59: | ||
<br><br> | <br><br> | ||
− | |||
− | |||
− | |||
<td> | <td> |
Revision as of 14:32, 16 February 2017
Revision 2.8Release Date: Not Released
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
The Default Tolerance Ends value is in the Inspection Data menu.
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature