Difference between revisions of "VTube-LASER v2.8"

From ATTWiki
Jump to: navigation, search
(25px NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values)
(25px NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values)
Line 56: Line 56:
 
The new commands are  
 
The new commands are  
  
* <code>array_dev_tmt_average</code><br><br>
+
* <code>array_dev_tmt_average</code><br>
 
* <code>array_dev_tmt_maximum</code>
 
* <code>array_dev_tmt_maximum</code>
  

Revision as of 14:30, 16 February 2017

Vtube-laser logo 1.96.png


Revision 2.8

Release Date: Not Released


Vtube-laser v2.7 screenshot.png

Contents


BUILD 11 - February 15, 2017

Check.jpg NEW: "Default Tolerance Ends" Value

The Default Tolerance Ends value is in the Inspection Data menu.

It allows you to set the end length default values separately from the tangent point / midpoint tolerance values.

Vtl-v2.8 Default End Tolerance.png




Check.jpg NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values

Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.

See the example result in the report on the right.

The report template source to create this table is shown below:

Vtl-2.8 inspection data tangent average and maximum html sample.png



The new commands are

  • array_dev_tmt_average
  • array_dev_tmt_maximum

Vtl-2.8 inspection data tangent average and maximum.png



Other Changes





Other Pages