Difference between revisions of "Revision: Benderlink for BLM 5.3"
(→25px NEW - Switch for "Do Not Allow Measuring Center to Change End Lengths") |
(→25px NEW - Message Warning for Ports That Cannot Open) |
||
Line 120: | Line 120: | ||
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
− | When a port to the measuring center cannot open, Benderlink now displays a message that a problem occurred. | + | When a COM port to the measuring center cannot open, Benderlink now displays a message that a problem occurred. |
</td> | </td> | ||
<td width=400> | <td width=400> | ||
Line 129: | Line 129: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
− | |||
− | |||
==Other Pages== | ==Other Pages== |
Revision as of 22:01, 14 October 2015
Revision 5.3
|
- See Benderlink for BLM Customer Support Page to download the latest version.
NEW - Large Green LED to Show Measuring Center Monitoring
A new larger green LED port indicator to show that Benderlink is monitoring for measuring center communications is added to the interface. |
NEW - Communications Transfers No Longer Change the BLM Radius Levels
Setting or changing BLM radius levels could easily cause radius level mix ups during corrections loops. The radius levels are no longer touched or changed during transfer. |
NEW - Switch for "Do Not Allow Measuring Center to Change End Lengths"
During CORRECTION of parts with extra material on the ends, it is helpful to not allow the end lengths to change. This keeps the carriage in approximately the same start position even after corrections are applied. |
ENHANCED - The Communications Protocol is Enhanced for LASERVISION Windows Version
The internal communications logic was enhanced to work properly with Windows versions of LASERVISION. (It already worked with DOS versions of LASERVISION.) |
NEW - Click on LEDs to Toggle to Measuring Center Monitoring
You can now click on either LED indicator to toggle monitoring for the measuring center commmands. |
FIXED - Ping Port Confirmation Works in Newer Windows
This feature allows Benderlink to ping for a serial device server before opening a virtual port. |
NEW - Message Warning for Ports That Cannot Open
When a COM port to the measuring center cannot open, Benderlink now displays a message that a problem occurred. |
Other Pages
- Back to Benderlink for BLM Revisions
- Back to Benderlink for BLM
- Back to Benderlink
- Go to the main website Benderlink for BLM page
- About BLM Group USA