Difference between revisions of "CNC Bender v14.7"
(→25px NEW: "Custom ALL DIES Open" Confirmation and Warning Messages) |
(→25px NEW: "Custom ALL DIES Open" Confirmation and Warning Messages) |
||
Line 65: | Line 65: | ||
</td> | </td> | ||
<td width=500> | <td width=500> | ||
− | [[image:cncbender_v14.7_custom_all_dies_open_option_messages.png| | + | [[image:cncbender_v14.7_custom_all_dies_open_option_messages.png|600px]] |
</td> | </td> | ||
</tr> | </tr> |
Revision as of 22:51, 24 July 2015
v14.7 - July 11, 2014
|
ENHANCED: Version 14 Is Now Compatible with Legacy I2T Servo Modules
Version 14 introduced compatibility with the new Galil module. This revision allows version 14 to communicate with legacy I2T modules also. |
NEW: "Custom ALL DIES Open" Option
This new option, when enabled, allows the operator to take over the control of how ALL dies open after each bend using CUSTOM COMMANDS. |
NEW: "Custom ALL DIES Open" Confirmation and Warning Messages
Prebend confirmation messages and warning messages will display when the new Custom ALL DIES Open option is enabled and AUTOBUILD is run. The CONFIRMATION messageEVERYTHING Looks OK - but this is a check to be sure you intend to ENABLE "Custom ALL DIES Open" after BEND 2. This means that the dies will NOT AUTOMATICALLY open after this bend unless CUSTOM COMMANDS have been created to handle all dies opening. If this is what you intend to do, then bring the "Disable AUTO and STEP MODE" to its UP position, which will let you run this program. The WARNING messageWARNING: There is a BYPASSED COMMAND. The option "Custom ALL DIES Open" is IGNORED in BEND 2 because the CUSTOM Commands IS NOT ENABLED for this bend. The dies will open using the standard order. To SOLVE THIS ISSUE, either create and ENABLE CUSTOM Commands for Bend 2, or DISABLE "Custom ALL DIES Open".
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands