Difference between revisions of "VTube-LASER v2"
From ATTWiki
(→25px NEW: Winton WMC Bender Data File Setup Window) |
(→25px ENHANCED: SUPRAVISION Network Engine Now Handles Benders with Inverted Rotations) |
||
(3 intermediate revisions by one user not shown) | |||
Line 49: | Line 49: | ||
</table> | </table> | ||
− | ===[[image:Check.jpg|25px]] | + | ===[[image:Check.jpg|25px]] NEW: SUPRAVISION Network Engine Now Handles Benders with Inverted Rotations=== |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> |
Latest revision as of 23:36, 16 February 2015
Revision 2.00
|
NEW: VTube Path Manager - Saves Time By Storing Important Paths
This change to VTube is a huge time-saver. Customers that have tested this feature report that they are very happy it. |
NEW: Winton WMC Bender Data File Setup Window
The new window allows VTube users to edit the data inside a Winton WMC file before exporting or adjusting a WMC file. |
NEW: SUPRAVISION Network Engine Now Handles Benders with Inverted Rotations
The Supravision network engine now allows for rotations to be inverted for benders that have rotations that move in the opposite direction to VTube. |
ENHANCED: CSM and ALPINE File Data Transfer Tested and Improved
|
Other Changes
- The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.
- The installation performs a better job of setting up the configuration file location.
- The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.
- We fixed a ball probe measurement issue where VTube would sometimes not always take in single points from the FARO driver. This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue.
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor