Difference between revisions of "VTube-STEP v2"
From ATTWiki
(→25px FIXED: Ball Probe Issue) |
(→25px ENHANCED: CSM and ALPINE File Data Conversions) |
||
Line 48: | Line 48: | ||
</table> | </table> | ||
− | ===[[image:Check.jpg|25px]] ENHANCED: CSM and ALPINE File Data Conversions=== | + | ===[[image:Check.jpg|25px]] ENHANCED: CSM and ALPINE File Data Conversions Are Better=== |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
Line 59: | Line 59: | ||
</tr> | </tr> | ||
</table> | </table> | ||
− | |||
===[[image:Check.jpg|25px]] ENHANCED: SUPRAVISION NETWORK Engine=== | ===[[image:Check.jpg|25px]] ENHANCED: SUPRAVISION NETWORK Engine=== |
Revision as of 22:20, 16 February 2015
Revision 2.0
|
- See VTube-STEP Customer Support Page to download the latest version.
NEW: VTube Path Manager
This change to VTube is a huge time-saver. Customers that have tested this feature report that they are very happy it. |
FIXED: Ball Probe - Points Not Incoming
We fixed a ball probe measurement issue where VTube would sometimes not always seem to take in the single points from the FARO driver. This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue. |
ENHANCED: CSM and ALPINE File Data Conversions Are Better
|
ENHANCED: SUPRAVISION NETWORK Engine
The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly. |
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER