Difference between revisions of "VTube Communication with YLM Benders"
(→Follow these steps at the YLM CONTROL to import the measured data from VTube-LASER) |
(→Follow these steps at the YLM CONTROL to import the measured data from VTube-LASER) |
||
Line 215: | Line 215: | ||
'''STEP 2'''<br>Search for and select the $$$ file that was created by VTube-LASER.<br><br> | '''STEP 2'''<br>Search for and select the $$$ file that was created by VTube-LASER.<br><br> | ||
'''STEP 3'''<br>Select COMPARE to bring the data into the YLM control. The COMPARE button will only display when a file is selected. | '''STEP 3'''<br>Select COMPARE to bring the data into the YLM control. The COMPARE button will only display when a file is selected. | ||
+ | <br><br>'''NOTE: DO NOT press the IMPORT button for corrections. Pressing IMPORT will make the correction data the nominal data - which would be incorrect.'''<br><br> | ||
</td> | </td> | ||
<td width=400> | <td width=400> | ||
Line 223: | Line 224: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
− | |||
'''STEP 4'''<br>Press the menu close button in the lower right corner.<br><br> | '''STEP 4'''<br>Press the menu close button in the lower right corner.<br><br> | ||
</td> | </td> |
Revision as of 00:17, 24 January 2015
|
Contents |
YLM Control software
The YLM Windows software allows for complete programming of bender setup. |
VTube-STEP and VTube-LASER Support for YLM Benders
VTube-STEP can export Supravision data to YLM benders. |
Using VTube-LASER to send NEW MASTER Data to YLM Benders
The connection the bender is made with standard network connection, and a shared folder location between the VTube computer and the operator station computer. For a NEW TUBE, the YLM takes in VTube MASTER Supravision LRA data in a Supravision file.
|
Follow these steps at VTube-LASER to Send a NEW TUBE SETUP to a YLM Bender
STEP 1 |
Follow these steps at the YLM CONTROL to import the MASTER data from VTube-LASER
STEP 1 |
|
STEP 2 |
|
STEP 3 |
|
STEP 4 |
|
STEP 5 |
|
STEP 6 |
VTube-LASER CORRECTION Steps for YLM Benders
The connection the bender is made with standard network connection, and a shared folder location between the VTube computer and the operator station computer.
|
Follow these steps at VTube-LASER to Correct a YLM Bender
STEP 1 |
|
STEP 2 |
|
STEP 3 |
Follow these steps at the YLM CONTROL to import the measured data from VTube-LASER
STEP 1 |
|
STEP 2 |
|
STEP 4 |
Shutdown to Edit the Windows Setup
To shutdown the YLM software to configure Windows settings:
- Press the Shutdown button.
- Press "NO" for shutdown.
- Type "12345" and OK in the numeric keypad.
- YLM will close without shutting down the computer.
Other Pages
- See VTube-LASER
- See VTube-STEP