Difference between revisions of "Eaton Leonard Lightspeed Communications Setup"
From ATTWiki
(→STEP 2: Device Config / Machine Menu) |
(→STEP 2: Device Config / Machine Menu) |
||
Line 49: | Line 49: | ||
Select a Measure Machine tab. LightSpeed can store four simultaneous measuring center setups for connection to multiple measuring centers.<br><br> | Select a Measure Machine tab. LightSpeed can store four simultaneous measuring center setups for connection to multiple measuring centers.<br><br> | ||
− | * NAME: The | + | * NAME: The name value has no effect on the protocol. However, you can give the setup a name here.<br><br> |
* PROTOCOL: Select the SupraGauge protocol.<br><br> | * PROTOCOL: Select the SupraGauge protocol.<br><br> | ||
* BENDER NUMBER: Set the bender to an integer number that identifies it. This is very important if you have multiple benders that share the same network location for transfer of data files.<br><br> | * BENDER NUMBER: Set the bender to an integer number that identifies it. This is very important if you have multiple benders that share the same network location for transfer of data files.<br><br> |
Revision as of 16:04, 17 June 2014
This document outlines the basic communications setup for a Lightspeed control. |
|
|
SVNET Communications Setup
STEP 1: System Menu
Change to the Systems menu. If you are not running the operator station as an administrator, then press SECURITY and enter the administrator code. (The default code is "123".) Press the DEVICE CONFIG button. |
STEP 2: Device Config / Machine Menu
In DEVICE CONFIG, enter the MACHINE menu. Select a Measure Machine tab. LightSpeed can store four simultaneous measuring center setups for connection to multiple measuring centers.
|
|
|