Difference between revisions of "CNC Bender v12.7"

From ATTWiki
Jump to: navigation, search
(25px ENHANCED: PostBend Release Mode Has a New Mode)
(25px ENHANCED: Load and Start Positions with Bend Arm Motion)
Line 36: Line 36:
 
Use this in conjunction with the PostBend Release command where you can turn off the bend arm return during release.</td>
 
Use this in conjunction with the PostBend Release command where you can turn off the bend arm return during release.</td>
 
<td width=300>
 
<td width=300>
[[image:cncbender_ArmToHomeInPrebend.png|400px]]
+
[[image:cncbender_ArmToHomeInPrebend.png|500px]]
 
</td>
 
</td>
 
<td>
 
<td>

Revision as of 04:07, 21 January 2014

v12.4 - January 20, 2014

Cncv12procontrol withteachmode.jpg


Check.jpg ENHANCED: Load and Start Positions with Bend Arm Motion

CNC Bender PreBend has a new option called "Arm to Home Mode" that controls when the bend arm returns home before bending begins. The goal is optimization of the cycle.

These are the choices:

1: Before Move to Load
2: During Move to Load
3: After Move to Load
4: After Chuck Close
5: During Move to Start
6: After Move to Start

Use this in conjunction with the PostBend Release command where you can turn off the bend arm return during release.

Cncbender ArmToHomeInPrebend.png



Check.jpg ENHANCED: Post Bend Release Mode Has a New Mode

A new ninth option is added to the Post Bend Release Modes. This mode can be used with the new Arm to Home Mode to switch off the arm homing at the end of the cycle.

Cncbender autodieswithoutarm.png



Check.jpg Other Changes

  • The HAND BENDER MODE of CNC Bender is enhanced to allow for Bending without the Feed axis following. This is helpful for applications where the last bend will pull the chuck into the pressure die or inside wiper die.



Other Pages