Difference between revisions of "CNC Bender v12.2"
From ATTWiki
(→25px ENHANCED: New BendPDAFeed Gearing Option) |
(→25px NEW: BendPDAFeed Gearing Option) |
||
Line 27: | Line 27: | ||
*This option works only with Feed Bending. | *This option works only with Feed Bending. | ||
− | *This option will take into account the Feed Distance Adjust percentages in the Tool page and the Bend options. | + | *This option will take into account the Feed Distance Adjust percentages in the Tool page and the Bend options. (The adjust percentages in the two locations are added together before being applied to the gearing.) |
*This option ignores the Feed SPEED Adjust percentages in the Bend options - because the speed is completely dependent on the gear ratio determined by the arc length plus the adjustment percentages. | *This option ignores the Feed SPEED Adjust percentages in the Bend options - because the speed is completely dependent on the gear ratio determined by the arc length plus the adjustment percentages. | ||
− | |||
==[[image:Check.jpg|25px]] NEW: BendPDAFeed Gearing Option == | ==[[image:Check.jpg|25px]] NEW: BendPDAFeed Gearing Option == |
Revision as of 02:32, 25 September 2013
v12.1.2 - August 30, 2013
|
NEW: BendPDAFeed Gearing Option
CNC Bender can now gear the PDA and Feed axis to the Bend arm motion at the same time.
- Enable this option in the Low Level menu.
- The option requires special wiring of the I2T IFC 220E motion cards.
- This option works only with Feed Bending.
- This option will take into account the Feed Distance Adjust percentages in the Tool page and the Bend options. (The adjust percentages in the two locations are added together before being applied to the gearing.)
- This option ignores the Feed SPEED Adjust percentages in the Bend options - because the speed is completely dependent on the gear ratio determined by the arc length plus the adjustment percentages.
NEW: BendPDAFeed Gearing Option
CNC Bender can now gear the PDA and Feed axis to the Bend arm motion at the same time.
Enable this option in the Low Level menu.
The option requires special wiring of the I2T IFC 220E motion cards.
ENHANCED: CIO Dictionary Editor Utility Added
The CIO Dictionary can now change the module names of given module to a new module name in the utilities menu.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands