Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 2 - Enter the Bender Data Setup Menu) |
(→STEP 3 - Establish Current Bender Values in the Blue Columns) |
||
Line 48: | Line 48: | ||
* To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | * To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | ||
* To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or printout and enter the data in the blue columns manually.<br><br> | * To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or printout and enter the data in the blue columns manually.<br><br> | ||
− | [[image:vtube_benderdatasetup_bluecol_nonzeros.jpg| | + | [[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] |
</td> | </td> | ||
<td width=300> | <td width=300> |
Revision as of 03:39, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
STEP 1 - Measure and Align the Measured Tube with the Master
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
STEP 3 - Establish Current Bender Values in the Blue Columns
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.
|
Other Pages
- Back to VTube-LASER