Difference between revisions of "CNC Bender v12-20120830"
From ATTWiki
(3 intermediate revisions by one user not shown) | |||
Line 15: | Line 15: | ||
__NOTOC__ | __NOTOC__ | ||
− | === [[image:Check.jpg|25px]] | + | === [[image:Check.jpg|25px]] ENHANCED: Autoloader Manual Page Redesign === |
Line 39: | Line 39: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
− | Three new | + | Three new processlists were added: |
#autoloader_home.cncprocesslist | #autoloader_home.cncprocesslist | ||
Line 45: | Line 45: | ||
#autoloader_liftdown.cncprocesslist | #autoloader_liftdown.cncprocesslist | ||
− | + | <br> | |
These three processlists control the jogging that occurs behind the | These three processlists control the jogging that occurs behind the | ||
− | + | #Autoloader Home button | |
− | + | #Lift Up button | |
− | + | #Lift Down button | |
− | + | <br> | |
Rules: | Rules: | ||
# The processlists do not need to exist - however, the buttons in the manual page will do nothing unless commands are inside the processlists. | # The processlists do not need to exist - however, the buttons in the manual page will do nothing unless commands are inside the processlists. | ||
# No block logic is accepted ([IF], etc.) in these processlists. | # No block logic is accepted ([IF], etc.) in these processlists. | ||
− | # Parameters | + | # Parameters ARE allowed - like "= cto:5000", etc. |
+ | # The commands in the processlists are treated like individual jogs. | ||
+ | </td> | ||
+ | |||
+ | <td width=300> | ||
+ | </td> | ||
+ | </tr> | ||
+ | </table> | ||
+ | |||
+ | |||
+ | |||
+ | ===[[image:Check.jpg|25px]] NEW: Added New Help Files === | ||
+ | |||
+ | <table cellpadding=10> | ||
+ | <tr valign=top> | ||
+ | <td width=400> | ||
+ | Two new help files were added for the new low level options. | ||
</td> | </td> | ||
Latest revision as of 11:24, 30 August 2012
v12-20120830
|
ENHANCED: Autoloader Manual Page Redesign
NEW: Added new Processlists for Autoloader Buttons
Three new processlists were added:
These three processlists control the jogging that occurs behind the
Rules:
|
NEW: Added New Help Files
Two new help files were added for the new low level options. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands