Difference between revisions of "CNC Bender v12-20120629"

From ATTWiki
Jump to: navigation, search
(25px Repair - Default Option Values in the Toolbox Now Switched Off)
(25px Repair - Default Option Values in the Toolbox Now Switched Off)
Line 20: Line 20:
 
By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox.
 
By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox.
 
<br><br>
 
<br><br>
However, the CNC Processlist Builder had difficulty determining if an option was inside the toolbox - even if it was inside the toolbox in CNC Bender.  This sometimes caused hard-to-trace side-effects where an option seemed to be active - and causing unintended effects like skipping bends, or calling out to features that were placed in the toolbox.
+
However, the CNC Processlist Builder improperly tracked if an option was inside the toolbox.  This sometimes caused hard-to-trace side-effects where an option seemed to be OUT of the Toolbox to Processlist Builder, but was inside the Toolbox in CNC Bender.  Unintended effects could be as serious as skipping bends for example.
 
<br><br>
 
<br><br>
 
This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in.   
 
This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in.   

Revision as of 00:45, 30 June 2012

v12-20120629

Cncv12procontrol withteachmode.jpg

Check.jpg Repair - Default Option Values in the Toolbox Now Switched Off

By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox.

However, the CNC Processlist Builder improperly tracked if an option was inside the toolbox. This sometimes caused hard-to-trace side-effects where an option seemed to be OUT of the Toolbox to Processlist Builder, but was inside the Toolbox in CNC Bender. Unintended effects could be as serious as skipping bends for example.

This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in.

Check.jpg Repair - Robot Clear Bit Can Be High or Low

The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.

Other Pages