Difference between revisions of "End-Scan Using the Scissor Motion"
From ATTWiki
Line 55: | Line 55: | ||
* Align the scanner with a slight scissor angle across the end as is shown in the image on the right<br><br> | * Align the scanner with a slight scissor angle across the end as is shown in the image on the right<br><br> | ||
* For repeatability: Hold the probe still.<br><br> | * For repeatability: Hold the probe still.<br><br> | ||
+ | Holding the probe motionless during scanning is important. If you move the probe during scanning the end, then repeatability will drop significantly because of exposure changes where the probe falls off the end of the tube.<br><br> | ||
+ | Likewise, striking the same end location is important during each repeat measure. | ||
+ | |||
*Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br> | *Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br> | ||
[[image:EndWithScissorCloseup.jpg|300px]]<br><br> | [[image:EndWithScissorCloseup.jpg|300px]]<br><br> | ||
− | |||
− | |||
</td> | </td> | ||
<td width=300> | <td width=300> |
Revision as of 03:25, 1 February 2012
How to perform quick scissor motion end-scans.
|
Why the End-Scan technique is important
This end-scan method is useful for ease-of-use and quickness.
|
Measure Setup
|
How To Use This End-Scan Technique
Holding the probe motionless during scanning is important. If you move the probe during scanning the end, then repeatability will drop significantly because of exposure changes where the probe falls off the end of the tube.
|
Other Pages
- See also End-Scan Using the End Wall
- See also End-Scan Using End Targets
- Back to VTube-LASER