Difference between revisions of "VTube-LASER v1.61"
From ATTWiki
Line 38: | Line 38: | ||
<td width=300> | <td width=300> | ||
If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube.<br><br> | If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube.<br><br> | ||
− | The Part Setup on the right is from a measurement of B end tube straight where | + | The Part Setup on the right is from a measurement of B end tube straight where a 1.130" expansion was measured. End B was set to zero, and VTube automatically filled in the expanded end diameter. |
</td> | </td> | ||
<td width=400> | <td width=400> |
Revision as of 21:38, 4 March 2011
Revision 1.61Back to VTube-LASER |
NEW: Floating End Letters
Floating end letters can be switched on to help identify the ends A and B of the tube.
|
NEW: Can Automatically Expanded or Reduced End A and End B Diameter
If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube. |
ENHANCED: New Options in Part Setup
Other Changes
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER