Difference between revisions of "VTube-LASER v1.61"
From ATTWiki
Line 32: | Line 32: | ||
<br><br> | <br><br> | ||
− | ===[[image:Check.jpg|25px]] NEW: Automatically | + | ===[[image:Check.jpg|25px]] NEW: Can Automatically Expanded or Reduced End A and End B Diameter=== |
<table cellpadding=10> | <table cellpadding=10> | ||
Line 38: | Line 38: | ||
<td width=300> | <td width=300> | ||
If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube.<br><br> | If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube.<br><br> | ||
+ | The Part Setup on the right is from a measurement of B end tube straight with a larger diameter. End B was set to zero, and VTube automatically filled in the expanded end diameter. | ||
</td> | </td> | ||
<td width=400> | <td width=400> |
Revision as of 21:36, 4 March 2011
Revision 1.61Back to VTube-LASER |
NEW: Floating End Letters
Floating end letters can be switched on to help identify the ends A and B of the tube.
|
NEW: Can Automatically Expanded or Reduced End A and End B Diameter
If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube. |
ENHANCED: New Options in Part Setup
Other Changes
|
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER