Difference between revisions of "CNC Bender v12-20110128"

From ATTWiki
Jump to: navigation, search
(25px ENHANCED - Teach Mode Button Can Be Invisible)
(25px ENHANCED - Teach Mode Button Can Be Invisible)
Line 35: Line 35:
 
<td width=300>
 
<td width=300>
 
Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list.
 
Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list.
 +
<br>
 +
[[image:teachbuttoninvisible_button.jpg]]
 
</td>
 
</td>
  

Revision as of 22:47, 28 January 2011

v12-20110128

Cncv12procontrol withteachmode.jpg


Check.jpg NEW - Process List Commands Can Ignore STEP Mode

Some commands don't move the actuators on bender. They only setup the bender. Now these commands can be told to not PAUSE during STEP MODE. This will reduce the number of run-button or foot-pedal steps required to run through a part on the bender in STEP mode.

The COMDEF Editor has a new "Ignore STEP Mode" checkbox for each COMMAND.

Comdefeditor ignorestepmode.jpg

Check.jpg ENHANCED - Teach Mode Button Can Be Invisible

Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list.
Teachbuttoninvisible button.jpg

Teachbuttoninvisible option.jpg



Other Pages