Difference between revisions of "CNC Bender v12-20110128"
From ATTWiki
| Line 24: | Line 24: | ||
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:comdefeditor_ignorestepmode.jpg| | + | [[image:comdefeditor_ignorestepmode.jpg|400px]] |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 22:39, 28 January 2011
v12-20110128
|
|
NEW - Process List Commands Can Ignore STEP Mode
|
Some commands don't move the actuators on bender. They only setup the bender. Now these commands can be told to not PAUSE during STEP MODE. This will reduce the number of run-button or foot-pedal steps required to run through a part on the bender in STEP mode.
|
|
ENHANCED - Empty Process Lists Now Allowed
|
Empty process lists are now allowed in CNC Bender. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
