Difference between revisions of "VTube-LASER v1.58"
Line 24: | Line 24: | ||
<br><br> | <br><br> | ||
[[image:vtube-laser_1_58_constructtube_control.jpg|200px]] | [[image:vtube-laser_1_58_constructtube_control.jpg|200px]] | ||
− | |||
− | |||
</td> | </td> | ||
<td width=300> | <td width=300> |
Revision as of 02:44, 19 January 2011
Revision 1.58Back to VTube-LASER |
NEW: Construct Tube in 3D Space
The new Construct Tube Control (shown above) allows you to point to any location in space to designate an end point or an intersection point. It also allows you to increase the number of straights/points on-the-fly. This allows operators to change the number of points at any time during the measurement process. |
ENHANCED: Measure Tube Control - Decrease / Increase Button
Operators can now increase or decrease the number of straights to measure in the tube on-the-fly if necessary. The new Decrease/Increase buttons are inserted on the control.
|
NEW: Show SCANNED or CALCULATED Graphic Data Any Time
VTube now allows operators to show or hide the orange scanned points or the large orange calculated end and intersection points at any time. |
NEW: Auto Display SCANNED and CALCULATED
The Draw Options feature is new to Measure Setup. You can select these two options if you want the SCANNED or the CALCULATED data to display or not during measurement. If both features are unchecked, then the tube measurement shows now realtime graphics data during measurement - like other measurement software. |
ENHANCED: Highlighted Cylinder Fit Box During High Error
The cylinder fit box highlights to YELLOW when it encounters a measurement in the tube that is outside the preprogrammed tolerance for cylinder fit. |
Other Pages
- Back to VTube-LASER