Difference between revisions of "CNC Bender v12-20100903"
From ATTWiki
Line 22: | Line 22: | ||
<td> | <td> | ||
[[image:cncbender_pressenable_to_switch_to_autostep.jpg|450px]]<br> | [[image:cncbender_pressenable_to_switch_to_autostep.jpg|450px]]<br> | ||
+ | </td> | ||
+ | </tr> | ||
+ | |||
+ | <tr valign=top> | ||
+ | <td width=300> | ||
+ | |||
+ | </td> | ||
+ | <td> | ||
+ | </td> | ||
+ | </tr> | ||
+ | </table> | ||
+ | |||
+ | |||
+ | |||
+ | ===[[image:Check.jpg|25px]] ENHANCED - Vertical Head Shift Tolerance Added === | ||
+ | <table cellpadding=10> | ||
+ | <tr valign=top> | ||
+ | <td width=200> | ||
+ | |||
+ | The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position.<br><br> | ||
+ | The tolerance value is now present in the Low Level General Options list and is used by the processlist compiler to give the Processor more efficient processlists.<br><br> | ||
+ | </td> | ||
+ | <td> | ||
+ | [[image:cncbender_vertical_head_shift_tolerance_options.jpg|450px]]<br> | ||
</td> | </td> | ||
</tr> | </tr> |
Revision as of 20:25, 30 August 2010
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands