Difference between revisions of "CNC Bender v12-20100903"
From ATTWiki
Line 17: | Line 17: | ||
<td width=200> | <td width=200> | ||
− | The "REQUIRE ENABLE BUTTON" feature now also monitors for a switch to AUTO or STEP modes from MANUAL mode <br><br> | + | The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode <br><br> |
When this feature is enabled, then the ENABLE button must be pressed or a large message will display indicating that the operator must press the ENABLE button<br><br> | When this feature is enabled, then the ENABLE button must be pressed or a large message will display indicating that the operator must press the ENABLE button<br><br> | ||
</td> | </td> |
Revision as of 20:22, 30 August 2010
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands