Difference between revisions of "CNC Bender v12-20100820"
Line 126: | Line 126: | ||
</tr> | </tr> | ||
</table> | </table> | ||
+ | <br><br> | ||
===[[image:Check.jpg|25px]] NEW - KEY Switch to EDIT Feature === | ===[[image:Check.jpg|25px]] NEW - KEY Switch to EDIT Feature === |
Revision as of 00:53, 21 August 2010
NEW - Servo Status Grid Now Always Visible on Main Screen
The status of up to 20 servo axes are now displayed at all times in a grid on the top of the screen. |
|
NEW - BIG Messages
For important events, CNC Bender now displays large messages for short periods of time. This lets operators clearly know what the control needs them to do next.
|
|
NEW - Press ENABLE to Jog
ENHANCED - CNC Processor CPU Usage DECREASED 60%
CNC Bender was optimized so that CNC Bender / CNC Processor CPU Usage was dropped by an average of 60% without any degradation in bender performance. The typical CPU usage during - even during bending - is now from 8 to 25%, with periodic spikes to 35%.
This optimization has the benefit of causing CNC Bender user interface to run much more quickly. |
|||||
NEW - KEY Switch to EDIT Feature
NEW - MANDREL LUBE with TIMER in FOUR OPTION LISTS
The new Mandrel Lube With Timer option allows operators to lube the mandrel for a period of milliseconds
|
|
Setup the feature in the low level menu - general dynamic options by naming the secondary process list names:
|
NEW - EMBEDDED TUBE SUPPORT in CNC PROCESSOR
This feature allows CNC Bender's PROCESSOR to control when the tube support is lifted or dropped - and if the drop should be confirmed with an input.
|
|
CHANGES - CNC Processor Configuration File
The following additions have been made to the configuration file:
|
ADD these to the CNCProcessor.cfg file: [Smart Inspect Logging] Enabled=0 Logging Method=TCPIP Filename=c:\cnc\logs\cncprocessor.sil TCPIP Address=192.168.0.190 [Loop] Main Loop Interval=0.100 Background Read Servo Loop Interval=0.100 |
Thee items on the right can be removed from the configuration file. They are no longer used in CNC Processor. |
REMOVE these from the CNCProcessor.cfg file: [Loop] Power Off Manual Mode Pause=250 Power On Manual Mode Pause=250 Cycle Hold Pause=100 [PRIORITY] Master Loop Priority=10000 |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands