Difference between revisions of "CNC Bender v11-20091218"
Line 116: | Line 116: | ||
<td width=300> | <td width=300> | ||
[[image:collision_immediate_message.jpg|200px]] | [[image:collision_immediate_message.jpg|200px]] | ||
+ | </td> | ||
+ | </tr> | ||
+ | |||
+ | </table> | ||
+ | |||
+ | <br><br> | ||
+ | |||
+ | ===[[image:Check.jpg|25px]] ENHANCE - TCP/IP Error Messages Now Include the Module Name=== | ||
+ | <table> | ||
+ | <tr valign=top> | ||
+ | <td width=300> | ||
+ | As of this version, the TCP/IP messages sent to the Immediate Message box include the module name that caused the problem. | ||
+ | <br><br> | ||
+ | This is a typical message now:<br><br> | ||
+ | '''[TCP/IP Errors] - STOPPING Communication with Modules (Problem with module: digital_output_221)''' | ||
+ | <br><br> | ||
+ | This places the module names directly in front of the user on the screen, rather than only in the TCP/IP log on disk. | ||
+ | </td> | ||
+ | |||
+ | <td width=300> | ||
+ | [[image:tcpip_modulename_immediate_message.jpg|200px]] | ||
</td> | </td> | ||
</tr> | </tr> |
Revision as of 17:15, 21 December 2009
|
REPAIR - Feed Accuracy Issues During Feed/Rotate Motion When Bend Arm Returning
|
|
CHANGE - Removed TOLERANCE Option from AXIS File
This feature was originally introduced in version CNC Bender 10.0.6.0m - Tolerance Move Skip in November of 2006. It was intended to reduce problems with the axes floating near zero, and Absolute moves having difficulty determining which way to move into position. (For example, the Feed axes could attempt to run backwards behind zero under very rare circumstances until version CNC Bender v11-20091201, where all axes are now kept far from internal zero.) Because of the permanent resolution to the absolute direction problem in version CNC Bender v11-20091201, and because of the problems caused by this option as discussed in previous sections, it was removed from CNC Bender. |
REPAIR - For [BEGIN RUN AGAIN] Feature
|
The benefit is removal of all latency when the process initializes all axes for loading the next part into the machine. |
REPAIR - Placed Collision Messages back in the Immediate Message Box
As of the previous version (CNC Bender v11-20091201), the collision warnings were no longer sent to the Immediate Message box.
|
ENHANCE - TCP/IP Error Messages Now Include the Module Name
As of this version, the TCP/IP messages sent to the Immediate Message box include the module name that caused the problem.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Final Feed Clearance