VTube NUMALLIANCE Bender Correction

From ATTWiki
Revision as of 23:09, 25 November 2019 by Mcone (Talk | contribs)

Jump to: navigation, search

VTube-LASER AssemblyOverModel.png RightOrangeArrow.png Numalliance Splash.png

This page describes how to use VTube-LASER to correct NUMALLIANCE benders.



Back to VTube-LASER

Contents


NUMALLIANCE CORRECTIONS

VTube-LASER has an export option for NUMALLIANCE MES files that are used to correct the NUMALLIANCE benders.

Note: NUMALLIANCE benders only require the measured data for corrections.

Measure the tube in VTube-LASER, then send the MEASURED tube data to the bender control, and it will then perform the correction.

Follow the steps below.

NumallianceCorrectionsSlide1.png



STEP 1

Press the Bender Setup button. (These steps assume that you have measured the tube and have setup VTube-LASER with the NUMALLIANCE protocol.)

Numalliance1.png



STEP 2

Choose the EXPORT tab menu.

NumallianceCorrectionSlide3.png




STEP 3

Choose the NUMALLIANCE CSV File option in the pulldown list.

NumallianceCorrectionSlide4.png




STEP 4

click the Export button.

NumallianceCorrectionSlide5.png



STEP 5

It is very important to enable the Positive Rotation options for most NUMALLIANCE benders. They normally rotate positive Clockwise when standing from the front of the bender.

If this setting is incorrect, then the rotations will be corrected in the wrong direction and cause the part to move further away from the nominal master part.

NumallianceCorrectionSlide6.png



STEP 6

Click on the Set the Filename button.

NumallianceCorrectionSlide7.png



STEP 7

Choose the export path in the Path Manager.

NumallianceCorrectionSlide8.png




STEP 8

Save the CSV file.

NumallianceCorrectionSlide9.png



STEP 9

Import the file into the NUMALLIANCE control.

NumallianceCorrectionSlide10.png



Other Pages