VTube End Length Offsets

From ATTWiki
Revision as of 02:15, 24 April 2014 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo.jpg
Vtube-step logo.jpg

Vtube-laser 1.77.3.jpg



  • It is possible to use end length adjustments to adjust the material length of the tube without moving the actual end point.

  • Use this to add material for end forms and other operations that require extra material.

  • These offsets will be added into the calculated Cut Length in the Part Setup menu.


Contents

How End LENGTH Offsets Work in VTube

End Length Offsets Add or Subtract Material Length

The end offsets in the Part Setup menu add or subtract material the ends in real-time.

This is the starting tube with no A End or B End offsets.

Vtube-offsetdemo nooffset.png

Entering a Positive Length Offset in the Part Setup Menu

We can change the B End Offset in the Part Setup menu like this:

Vtube-offsetdemo offset b end 3inches.png

Then we press F2 to refresh the graphics, and B end is made longer - without moving the end point.

Vtube-offsetdemo offset b end 3inches model1.png

Using Transparency to Show the Effect

Here is the result with transparency increased to 0.75:

Vtube-offsetdemo offset b end 3inches model2.png

Entering a Negative Length Offset in the Part Setup Menu

You can also subtract material from an end by using a negative value like this:

Vtube-offsetdemo offset b end minus2inches.png

Then press F2 to refresh the graphics, and B end material is made shorter without moving the end point.

Vtube-offsetdemo offset b end 3inches model3.png

Other Pages