Difference between revisions of "VTube-STEP v1.77.3"

From ATTWiki
Jump to: navigation, search
(25px UPDATED: View Orientation Control)
(25px ENHANCED: View Orientation Control Redesigned)
Line 26: Line 26:
 
You can click on the button or the image to find a new orientation.</td>
 
You can click on the button or the image to find a new orientation.</td>
 
<td width=300>
 
<td width=300>
 +
[[image:vtube_1.77.3_vieworientation.jpg|150px]]
 
</td>
 
</td>
 
</tr>  
 
</tr>  
 
</table>
 
</table>
[[image:vtube_1.77.3_vieworientation.jpg|150px]]
 
  
 
===[[image:Check.jpg|25px]] NEW:  End Lengths Change in Diameter Model with End Adjustment Length Values===
 
===[[image:Check.jpg|25px]] NEW:  End Lengths Change in Diameter Model with End Adjustment Length Values===

Revision as of 03:21, 8 August 2012

Vtube-step logo.jpg

Revision 1.77.3

Vtube-step 1.77.3a.jpg



Check.jpg ENHANCED: View Orientation Control Redesigned

Vtube 1.77.3 vieworientation closeup.jpg

The View Orientation Control has new choices with graphics icons of each axes orientation.

You can click on the button or the image to find a new orientation.

Vtube 1.77.3 vieworientation.jpg

Check.jpg NEW: End Lengths Change in Diameter Model with End Adjustment Length Values

Vtube 1.77.3 EndLengthShortened Closeup.jpg

When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location.

Vtube 1.77.3 EndLengthShortened.jpg

Check.jpg REPAIR: Cut Length Calculation with End Adjustments

Vtube endlength cutlength partsetup.jpg

The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version.

Other Pages