Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 42: | Line 42: | ||
===[[image:Check.jpg|25px]] REPAIR: Cut Length Calculation with End Adjustments=== | ===[[image:Check.jpg|25px]] REPAIR: Cut Length Calculation with End Adjustments=== | ||
| + | [[image:vtube_endlength_cutlength_partsetup.jpg|300px]] | ||
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
| Line 47: | Line 48: | ||
The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version.</td> | The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version.</td> | ||
<td width=300> | <td width=300> | ||
| − | |||
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
==Other Pages== | ==Other Pages== | ||
*Back to the [[VTube]] page | *Back to the [[VTube]] page | ||
Revision as of 03:17, 8 August 2012
|
Revision 1.77.3
|
|
UPDATED: View Orientation Control
|
The View Orientation Control has new choices with graphics icons of each axes orientation. |
|
NEW: End Lengths Change in Diameter Model with End Adjustment Length Values
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: Cut Length Calculation with End Adjustments
| The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version. |
Other Pages
- Back to the VTube page
