VTube-LASER v2.8.1

From ATTWiki
Revision as of 20:52, 6 May 2017 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png


Revision 2.8.1

Original Release Date: May 8, 2017
Latest Build: 70 - May 6, 2017


Vtube-laser v2.7 screenshot.png

Contents


BUILD 70 - May 6, 2017

Check.jpg NEW: END OFFSET POINT MODEL

This adds a second end point model of the end point before it is offset.

The extra model allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end.

In the top image on the right, the yellow ball represents the middle of the ball probe. The orange ball is the projected end point based on the compensation toward the end.

Vtube-laser v2.8.1 end offset model illustration.png

When the two points are within 0.1 mm (0.0039 inches) of within each other, then VTube only draws the final orange ball.

Vtube-laser v2.8.1 end offset model.png

Ball probe orange tube.png




Check.jpg NEW: NOTIFICATION FOR LASER TOGGLE

As of this version if VTube-LASER toggles from LASER to ball probe or ball probe to LASER, it notifies you with a sound and a guide box message.

Vtube-laser v2.8.1 notification for toggle laser.png

Vtube-laser v2.8.1 notification for toggle laser to laser.png



Other Pages