VTube-LASER v2.8

From ATTWiki
Revision as of 14:26, 16 February 2017 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png


Revision 2.8

Release Date: Not Released


Vtube-laser v2.7 screenshot.png

Contents


BUILD 11 - February 15, 2017

Check.jpg NEW: "Default Tolerance Ends" Value

The Default Tolerance Ends value is in the Inspection Data menu.

It allows you to set the end length default values separately from the tangent point / midpoint tolerance values.

Vtl-v2.8 Default End Tolerance.png




Check.jpg NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values

Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.

See the example result in the report on the right.

The report template source to create this table is shown below:

Vtl-2.8 inspection data tangent average and maximum html sample.png



The new commands are "array_dev_tmt_average" and "array_dev_tmt_maximum".

Vtl-2.8 inspection data tangent average and maximum.png



Other Changes





Other Pages