VTube-LASER v2.5

From ATTWiki
Revision as of 23:36, 28 March 2016 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png

Revision 2.5

Vtube-laser 1.89 mainscreen.png

Contents


Check.jpg IMPROVED: Best Fit - Automatic End Weight Version 2 - Tighter and Faster Alignments

We're always happy to give you a feature that does more - and does it FASTER than before. This is one of those features.

Version 2 of the Best Fit engine aligns tube shapes faster and tighter than the original. For example, a 25 second alignment is now made in 20 seconds, and a 0.013" average deviation might drop to an average of 0.009".

Version 1 was very good at tight alignments as the measured tube shape started to conform more to the master tube shape. However, version 2 creates a tighter fit faster - and handles shapes that are further from the master shape much better than version 1.

The two alignments shown here are the results of the two versions of alignments in version 2.5 using the same master/measured data. When qualifications are on the edge of the tolerance, then this extra tight alignment can pay off. Not only is the alignment tighter, but Version 2 has extra logic that gives more emphasis to increasing the number of TANGENT and MIDPOINT CELLS that are within tolerance.

Note: We understand that some customers are very careful when approving new part alignment algorithms - so we were careful to leave the original version Best Fit option in the VTube Inspection Results menu to give you time to learn to trust and use Best Fit version 2.

Vtube-laser v2.5 bestfit version1.png

Vtube-laser v2.5 bestfit version2.png

Check.jpg FIX: Automatic Image Refresh In Report Window

We discovered and fixed a problem with this feature. It works reliably now in version 2.4.

Vtube v2.4 automatic image refresh.png





Other