VTube-LASER v1.99

From ATTWiki
Revision as of 01:34, 26 November 2014 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo.jpg

Revision 1.99

Vtube-laser 1.89 mainscreen.png



Check.jpg NEW: Alpine M4 Bender Correction

The Alpine M4 bender format was added to VTube-LASER.

This allows VTube-LASER to correct the control in a full bi-directional corrections loop.

This new feature also stores all the YBC data in the M4 format inside the VTube project files - which means the bender setup is stored along with the project and recalled when the project is loaded back into VTube.

VTube-LASER-1.99 AlpineM4BenderCorrection.png


Check.jpg ENHANCEMENT: "Pull Arm from Cradle" Message REMOVED for Automatic Scan Modes

The message is of no value when the arm is running in automatic scan mode. It should only display when the scan algorithm is set to FIXED. This saves confusion for arm users that always use AUTOMATIC modes.

So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode.

Vtube-laser-1.99 armcradle message.png


Check.jpg ENHANCEMENT: Additional Setup Button Added for Winton WMC in Bender Setup

This new button allows users to modify the bender setup file before sending data to the bender.

VTube--LASER-1.99 WMC BenderSetup AdditionalSetupButton.png

Check.jpg ENHANCEMENT: Arm Connected LED Lamp Added to Arm Utilties

This new LED indicates that the arm is connected to the Arm Utilities menu.

Vtube-laser-1.99 LED lamp Arm Setup.png

Other