Difference between revisions of "VTube-LASER v1.62"

From ATTWiki
Jump to: navigation, search
(25px ENHANCED: End Scans Faster + New Progress Window)
(25px Other Changes)
Line 81: Line 81:
 
<tr>
 
<tr>
 
<td width=300>
 
<td width=300>
 +
* The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified.  This has been resolved in this version.
 
</td>
 
</td>
 
<td>
 
<td>

Revision as of 05:14, 12 March 2011

Vtube-laser logo.jpg

Revision 1.62

Back to VTube-LASER

Vtube-laser 1 62.jpg



Check.jpg ENHANCED: End Scans Faster + New Progress Window

Analysis of end scans is now at least twice as fast as in version 1.61.

When end-scans are taking more time than a few seconds, a progress window will display.

Vtube-laser endscan progresswindow.jpg



Check.jpg NEW: Scan Rate Types: Timer or Distance

Now all scan rates are determined by either a TIMER or a DISTANCE.

For end-scans, use a timer and set the timer value to 0 milliseconds.

For cylinder scans, you can use DISTANCE and set the Cylinder Scan Distance to whatever value is convenient for separation.

Vtube-laser measuresetup scanrates.jpg



Check.jpg NEW: Multiple Point Qualification End Scan

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points.

A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

Vtube-laser endscan fitwindow.jpg



Check.jpg REPAIR: Diameter and Wall Detection for STEP Mode

See VTube-STEP v1.62 for details.

Vtube-step 1 62.jpg



Check.jpg Other Changes

  • The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.



Check.jpg Issues with this version fixed in next version

  • No known issues

Other Pages