VTube-LASER Videos
From ATTWiki
See a complete list of VTube-LASER videos on this page.
|
Version 2.9.3
Video 1: Introduction to the MTA (Measured Tube Averaging) Feature
This video demonstrates how the MTA feature can measure both sides of the same tube to create a measured tube average for more reliable tube shape calculation. |
Version 1.94
Video 33: Reverse Engineering a Tube Using the Ball Probe
This is a tutorial by the developer of VTube-LASER, Michael Cone. Michael will show you how you can reverse engineer a tube with a FARO Edge arm and the ball probe. |
Video 32: The Benefits if Wide Diameter Scanning
This is a tutorial by the developer of VTube-LASER, Michael Cone. Michael will show you why wide diameter scanning is superior to other forms of scanning tubes. |
Video 31: How to Reverse-Engineer a Tube
This video shows how to reverse engineer a tube in VTube-LASER 1.94. |
Video 30: Springback Compensation Tutorial
This video shows how calculate the anticipated bend angle springback and then compensate the bend setup to make the first part shape close to the nominal shape. |
Other Pages
- See Retired VTube-LASER Videos
- Back to VTube-LASER